MINI Cooper R55,R56,R57 GoGraphic A-Pillar-White Checker

Everyone loves the look of crazy cool car graphics but wonder how hard they are to apply. We are here to ease your mind!Our GoGraphics have been designed with you in mind.

Our design team begins by looking for beautiful and unique areas for exterior visual expression. Once we identify what looks best, we prototype each design and install them ourselves. Each design is then fine tuned for look and installation ease. Finally, we manufacture with only the best 3M, Scotchprint or Controltac material that will last for years of fun and beautiful expression.

Feel confident in doing it yourself, select your look and go for it!

All GoGraphics come with easy to follow installation instructions, of course!

Dimensions for R55, R56, R57 GoGraphic A-Pillar

Top width: 3-1/4" (3.25") inches wide
Bottom width: 4-1/2" (4.5") inches long
Length: 23-5/8" (23.625") inches long

Features
PLEASE READ ALL INSTRUCTIONS BEFORE STARTING

TOOL REQUIRED:

1 Plastic Squeegee OR CREDIT CARD

PREPARATION:

The temperature of the room and the temperature of the intended surface should be between 45 and 90 degrees.

INSTALLATION

1. START BY CLEANING THE SURFACE

2. POSITION AND TEST THE GRAPHIC ON THE SURFACE. DO NOT SEPARATE LINER FROM PRE-MASK. This is to insure proper placement before the liner is removed.

3. SEPARATE LINER FROM PRE-MASK

4. CAREFULLY PLACE THE VINYL GRAPHIC (WITH PRE-MASK) ON THE SURFACE

5. USE SQUEEGEE TO APPLY VINYL GRAPHIC. WORK FROM THE CENTER OUT TO AVOID BUBBLES

6. REMOVE PRE-MASK

7. SQUEEGEE OVER THE ENTIRE GRAPHIC. Lay the piece of left over liner over the graphic with shiny side of liner facing you. Proceed to apply hard pressure to squeegee out any remaining air bubbles.